如何修改bonding的当前活动端口

Interface Bonding as we all know is very useful in providing the fault tolerance and increased bandwidth. We can change the active slave interface of bonding without interrupting the production work. In the example below we have the interface bonding bond0 with 2 slaves em0 and em1 (em1 being the active slave). We will be replacing slave em0 with new slave em2.

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: em0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 5000
Down Delay (ms): 5000

Slave Interface: em0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:21:28:b2:65:26
Slave queue ID: 0

Slave Interface: em1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:21:28:b2:65:27
Slave queue ID: 0

1. Change the active slave to em1

ifenslave command can be used to attach or detach or change the currently active slave interface from the bonding. Now, Change the active slave interface to em1.

# ifenslave -c bond0 em1

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: em1
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 5000
Down Delay (ms): 5000

Slave Interface: em0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:21:28:b2:65:26
Slave queue ID: 0

Slave Interface: em1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:21:28:b2:65:27
Slave queue ID: 0

2. Attach the new slave interface

We can now attache the new slave interface em2 to the bonding.

# ifenslave bond0 em2

3. Detach the old slave interface

Once we have attached a new slave interface, we can detach the old slave and remove it from the bonding.

# ifenslave -d bond0 em0

4. Verify

Confirm that the new slave is now the standby interface in the bonding.

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: em1
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 5000
Down Delay (ms): 5000

Slave Interface: em1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:21:28:b2:65:27
Slave queue ID: 0

Slave Interface: em2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:29:3a:c1:63:71
Slave queue ID: 0

refer:

RedHat / CentOS : How to change currently active slave interface of bonding online – The Geek Diary