cisco-华为设备单臂路由配置

1. cisco设备

1.1二层交换机配置

Switch(config)#vlan 10
Switch(config-vlan)#vlan 20
Switch(config-vlan)#int f0/1
Switch(config-if)#switch mode access
Switch(config-if)#switchport access vlan 10 
Switch(config)#int f0/2
Switch(config-if)#switch mode access
Switch(config-if)#switchport access vlan 20
Switch(config)#int f0/24
Switch(config-if)#switch mode trunk

1.2路由器配置

Router(config)#int f0/0
Router(config-if)#no shutdown 
Router(config)#int f0/0.10
Router(config-subif)#encapsulation dot1Q 10
Router(config-subif)#ip add 192.168.10.254 255.255.255.0
Router(config)#int f0/0.20
Router(config-subif)#encapsulation dot1Q 20
Router(config-subif)#ip add 192.168.20.254 255.255.255.0

测试：

2.华为设备配置

2.1 二层交换机配置

<SW1>system-view
[SW1]vlan batch 10 20
[SW1]int Ethernet 0/0/1	
[SW1-Ethernet0/0/1]port link-type access 	
[SW1-Ethernet0/0/1]port default vlan 10
[SW1]int Ethernet 0/0/2	
[SW1-Ethernet0/0/2]port link-type access 	
[SW1-Ethernet0/0/2]port default vlan 20
[SW1]int Ethernet 0/0/20
[SW1-Ethernet0/0/20]port link-type trunk 
[SW1-Ethernet0/0/20]port trunk allow-pass vlan 10 20

2.2 路由器配置

<Huawei>system-view 
[Huawei]sysname R1
[R1]int Ethernet 0/0/0.10
[R1-Ethernet0/0/0.10]dot1q termination vid 10
[R1-Ethernet0/0/0.10]ip address 192.168.10.254 24	
[R1-Ethernet0/0/0.10]arp broadcast enable 
[R1-Ethernet0/0/0.10]quit	
[R1]interface Ethernet 0/0/0.20	
[R1-Ethernet0/0/0.20]dot1q termination vid 20
[R1-Ethernet0/0/0.20]ip address 192.168.20.254 24	
[R1-Ethernet0/0/0.20]arp broadcast enable 

测试：