Linux中keepalive的使用

首先给大家分享一个巨牛巨牛的人工智能教程，是我无意中发现的。教程不仅零基础，通俗易懂，而且非常风趣幽默，还时不时有内涵段子，像看小说一样，哈哈～我正在学习中，觉得太牛了，所以分享给大家！点这里可以跳转到教程

               

/proc/sys/net/ipv4/tcp_keepalive_time当keepalive起用的时候，TCP发送keepalive消息的频度。缺省是2小时。

/proc/sys/net/ipv4/tcp_keepalive_intvl当探测没有确认时，重新发送探测的频度。缺省是75秒。

/proc/sys/net/ipv4/tcp_keepalive_probes在认定连接失效之前，发送多少个TCP的keepalive探测包。缺省值是9。这个值乘以tcp_keepalive_intvl之后决定了，一个连接发送了keepalive之后可以有多少时间没有回应。


tcp_keepalive_time（开启keepalive的闲置时长）tcp_keepalive_intvl（keepalive探测包的发送间隔） 和tcp_keepalive_probes （如果对方不予应答，探测包的发送次数）

There are two ways to configure keepalive parameters inside the kernel via userspace commands:

• procfs interface
• sysctl interface

We mainly discuss how this is accomplished on the procfs interface because it's the most used, recommended and the easiest to understand. The sysctl interface, particularly regarding the sysctl(2) syscall and not the sysctl(8) tool, is only here for the purpose of background knowledge.

The procfs interface

This interface requires both sysctl and procfs to be built into the kernel, and procfs mounted somewhere in the filesystem (usually on/proc, as in the examples below). You can read the values for the actual parameters by "catting" files in /proc/sys/net/ipv4/directory:

# cat /proc/sys/net/ipv4/tcp_keepalive_time  7200  # cat /proc/sys/net/ipv4/tcp_keepalive_intvl  75  # cat /proc/sys/net/ipv4/tcp_keepalive_probes  9

The first two parameters are expressed in seconds, and the last is the pure number. This means that the keepalive routines wait for two hours (7200 secs) before sending the first keepalive probe, and then resend it every 75 seconds. If no ACK response is received for nine consecutive times, the connection is marked as broken.

Modifying this value is straightforward: you need to write new values into the files. Suppose you decide to configure the host so that keepalive starts after ten minutes of channel inactivity, and then send probes in intervals of one minute. Because of the high instability of our network trunk and the low value of the interval, suppose you also want to increase the number of probes to 20.

Here's how we would change the settings:

# echo 600 > /proc/sys/net/ipv4/tcp_keepalive_time  # echo 60 > /proc/sys/net/ipv4/tcp_keepalive_intvl  # echo 20 > /proc/sys/net/ipv4/tcp_keepalive_probes

To be sure that all succeeds, recheck the files and confirm these new values are showing in place of the old ones.

这样，上面的三个参数配置完毕。

           

浏览人工智能教程