CentOS7出现could not retrieve mirrorlist 错误

Could not retrieve mirrorlist http://mirrorlist.centos.org/?release=7&arch=x86_64&repo=os&infra=stock error was
14: curl#6 - "Could not resolve host: mirrorlist.centos.org; Unknown error"

 One of the configured repositories failed (Unknown),
 and yum doesn't have enough cached data to continue. At this point the only
 safe thing yum can do is fail. There are a few ways to work "fix" this:

     1. Contact the upstream for the repository and get them to fix the problem.

     2. Reconfigure the baseurl/etc. for the repository, to point to a working
        upstream. This is most often useful if you are using a newer
        distribution release than is supported by the repository (and the
        packages for the previous distribution release still work).

     3. Disable the repository, so yum won't use it by default. Yum will then
        just ignore the repository until you permanently enable it again or use
        --enablerepo for temporary usage:

            yum-config-manager --disable <repoid>

     4. Configure the failing repository to be skipped, if it is unavailable.
        Note that yum will try to contact the repo. when it runs most commands,
        so will have to try and fail each time (and thus. yum will be be much
        slower). If it is a very temporary problem though, this is often a nice
        compromise:

            yum-config-manager --save --setopt=<repoid>.skip_if_unavailable=true

Cannot find a valid baseurl for repo: base/7/x86_64

使用yum无法检索到镜像列表，解决方法如下。

1. cd /etc/sysconfig/network-scripts 进入该文件夹后，然后再ls一下，查看是否有ifcfg-ens33，有时是ifcfg-eth0

2. vi ifcfg-ens33 进入VI的一般模式，移动光标到ONBOOT=no

3. 按下"i"进入VI的编辑模式，把no删除改为yes

4. 修改后按下esc再次进入一般模式，再按下":"到文件底部，在“：”后输入 “wq” （保存退出）

5. 重启一下centos，再次试一下ip addr和 yum, 就可以了。

附加: 如果在network-scripts里找到的是ifcfg-eth0文件，那就把以下两项改成如下，最后重启就行。

ONBOOT=yes MM_CONTROLLED=no