我的 redis3.*主从连接失败可能原因

-DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions:

（在主redis服务器上输入redis-cli xxx，其中x是你连接服务器的各种参数，然后在redis命令行输入CONFIG SET protected-mode no）
1. ) Just disable protected mode sending the command ‘CONFIG SET protected-mode no’ from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent.
（在启动redis的配置文件中找到 protected-mode yes 把他的注释取消掉设置为no,然后重启服务器)
2. ) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to ‘no’, and then restarting the server.
（在启动服务器时，在redis-server命令后面加上--protected-mode no 参数）
3. ) If you started the server manually just for testing, restart it with the ‘–protected-mode no’ option.
（在配置文件中配置bind参数，具体查看配置文件中的example, 或者 设置配置文件中的reparequirepass 密码 ,然后从服务器连接的时候配置 masterauth 密码 ）
4. ) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

以上一切都可以从redis配置文件中找到！！