----------------------------------------
Cisco
交
换
机
4506/4006
密
码
恢复
详细过
程
步
骤
:
1
、
打开
45
交
换
机的
电
源后,出
现
提示后按住
键盘
上的
“Ctrl
−
C”5
秒。然后
进
入系
统
ROM moniter
状
态
(ROMmon)
!
−−−
Here, you power cycle the switch.
**********************************************************
* Welcome to ROM Monitor for WS
−
X4014 System. *
* Copyright (c) 1999
−
2000, 2001 by Cisco Systems, Inc. *
* All rights reserved. *
**********************************************************
ROM Monitor Program Version 12.1(10r)EY(1.21)
Board type 1, Board revision 7
Swamp FPGA revision 16, Dagobah FPGA revision 43
Timer interrupt test passed.
MAC Address : 00
−
02
−
b9
−
83
−
af
−
fe
IP Address : 172.16.84.122
Netmask : 255.255.255.0
Gateway : 172.16.84.1
TftpServer : Not set.
Main Memory : 256 MBytes
***** The system will autoboot in 5 seconds *****
Type control
−
C to prevent autobooting.
!
−−−
At this point, press Ctrl+C.
Autoboot cancelled......... please wait!!!
Autoboot cancelled......... please wait!!!
rommon 1 > [interrupt]
!
−−−
The module ended in the ROMmon.
rommon 1 > [interrupt]
2
、
进
入了
ROMmon
模式后使用命令
“confreg”
进
入系
统
恢复
阶
段。
rommon 1 > confreg
Configuration Summary :
=> load ROM after netboot fails
=> console baud: 9600
=> autoboot from: commands specified in 'BOOT' environment variable
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]: n
enable "use net in IP bcast address"? y/n [n]: n
disable "load ROM after netboot fails"? y/n [n]: n
enable "use all zero broadcast"? y/n [n]: n
enable "break/abort has effect"? y/n [n]: n
enable "ignore system config info"? y/n [n]: y
change console baud rate? y/n [n]: n