Centos network adapter (hyper-v)

step one: form:: /etc/sysconfig/network-scripts/ifcfg-<name>

xmaple:/etc/sysconfig/network-scripts/ifcfg-eth0

step two:

        dynamic:

        TYPE=Ethernet

        PROXY_METHOD=none

        BROWSER_ONLY=no

        BOOTPROTO=dhcp

        DEFROUTE= yes

        IPV4_FAILURE_FATAL= no

        IPV6INIT=yes

        IPV6_AUTOCONF=yes

        IPV6_DEFROUTE=yes

        IPV6_FAILURE_FATAL=no

        IPV6_ADDR_GEN_MODE=stable-privacy

        NAME=eth0

        UUID=XXXXXXXX-XXXX

        DEVICE=eth0

        ONBOOT=yes//启动时激活

static ip:

  TYPE=Ethernet

        PROXY_METHOD=none

        BROWSER_ONLY=no

        BOOTPROTO=static

        IPADDR=192.168.0.18

        NETMASK=255.255.255.0

        NM_CONTROLLED=no

        DEFROUTE yes

        IPV4_FAILUE_FATAL= no

        IPV6INIT=ys

        IPV6_AUTOCONF=yes

        IPV6_DEFROUTE=yes

        IPV6_FAILURE_FATAL=no

        IPV6_ADDR_GEN_MODE=stable-privacy

        NAME=eth0

        UUID=XXXXXXXX-XXXX

        DEVICE=eth0

        ONBOOT=yes//启动时激活

=======《》=======

step three:service network restart 

done!

If you got something wrong,can try flowing

        execution command line "nmcli d " to show network status.

        if status is not activity then execution "ifup eth0" ,this eth0 is above NAME.and check status again.You'll see network is working if no accident.