本文档详细介绍了在Cygwin下构建GCC的t-arm-elf文件以支持ARM和Thumb代码生成、小端或大端架构、硬件或软件浮点指令等选项的过程。编译过程中涉及了binutils、GCC、newlib和GDB的配置与安装步骤，旨在创建一个支持interwork和multilib的ARM交叉编译链。
Build process
GCC's t-arm-elf file was updated to enable support for the following options:
- marm/mthumb (arm or thumb code generation)
- mlittle-endian/mbig-endian (little or big endian architectures)
- mhard-float/msoft-float (hardware or software fpu instructions)
- mno-thumb-interwork/mthumb-interwork (arm-thumb modes interworking)
- mcpu=arm7 (arm7 targets without hardware multiply)
The disabled options were mapcs-32/mapcs-26 (for old ARM machines with 26-bit program counters) and fno-leading-underscore/fleading-underscore (non-ELF library function format).
The following steps and configuration switches were used in the compilation process:
- cd [binutils-build]
- [binutils-source]/configure --target=arm-elf --prefix=[toolchain-prefix] --enable-interwork --enable-multilib
- make all install
最低0.47元/天 解锁文章
扫一扫
2471
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
