下载地址:https://pan.baidu.com/s/1-6GdVV_N34Jr9KYTCResFA 提取码: 1t8b
连接准备
基本上主要确认几点:redis实例是否启动成功、端口是否正常开放、redis.conf中bind配置是否允许你客户机连接、protected-mode是否处于保护模式。如果你telnet进出现下面的错误,可以先关闭保护模式,然后重启redis加载配置
-DENIED Redis is running in protected mode because protected mode is enabled,
no bind address was specified, no authentication password is requested to clients.
In this mode connections are only accepted from the loopback interface.
If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.
#修改成no
protected-mode no
连接:输入IP、端口,成功建立连接。如下图