水星1200r服务器无响应,【求助】水星MAC1200R TTL刷机中断u-boot失败

U-Boot 1.1.3 (Feb 28 2015 - 13:28:42)

Board: Ralink APSoC DRAM:  64 MB

relocate_code Pointer at: 83fb8000

flash manufacture id: ef, device id 40 17

find flash: W25Q64BV

*** Warning - bad CRC, using default environment

Autobooting in 1 seconds

## jump to 0xBC030000 ...

U-Boot 1.1.3 (Feb 28 2015 - 13:41:15)

Board: Ralink APSoC DRAM:  64 MB

relocate_code Pointer at: 83fc0000

flash manufacture id: ef, device id 40 17

find flash: W25Q64BV

*** Warning - bad CRC, using default environment

Now booting Linux!

Autobooting in 1 seconds

## Booting image at bc040000 ...

---- tpHdr = bc040000

---- text base = 80000000

---- entry point = 80000000

Uncompressing Kernel Image ... OK

No initrd

## Transferring control to Linux (at address 80000000) ...

## Giving linux memsize in MB, 64

Starting kernel ...

LINUX started...

THIS IS ASIC

[    0.000000] Linux version 3.10.14 (tplink@tplink-0B) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Feb 28 13:51:39 CST 2015

[    0.000000]

[    0.000000]  The CPU feqenuce set to 575 MHz

[    0.000000] CPU0 revision is: 00019655 (MIPS 24KEc)

[    0.000000] Software DMA cache coherency

[    0.000000] Determined physical RAM map:

[    0.000000]  memory: 04000000 @ 00000000 (usable)

[    0.000000] Initrd not found or empty - disabling initrd

[    0.000000] Zone ranges:

[    0.000000]   Normal   [mem 0x00000000-0x03ffffff]

[    0.000000] Movable zone start for each node

[    0.000000] Early memory node ranges

[    0.000000]   node   0: [mem 0x00000000-0x03ffffff]

[    0.000000] Primary instruction cache 64kB, 4-way, VIPT, linesize 32 bytes.

[    0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes

[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256

[    0.000000] Kernel command line: console=ttyS1,57600n8 root=/dev/mtdblock6 rootfstype=squashfs,jffs2 noinitrd rootfstype=squashfs,jffs2

[    0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)

[    0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

[    0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

[    0.000000] Writing ErrCtl register=00007cd7

[    0.000000] Readback ErrCtl register=00007cd7

[    0.000000] Memory: 61088k/65536k available (2770k kernel code, 4448k reserved, 647k data, 164k init, 0k highmem)

[    0.000000] NR_IRQS:128

[    0.000000] console [ttyS1] enabled

[    0.096000] Calibrating delay loop... 382.46 BogoMIPS (lpj=764928)

[    0.128000] pid_max: default: 32768 minimum: 301

[    0.132000] Mount-cache hash table entries: 512

[    0.136000] NET: Registered protocol family 16

[    0.140000] RALINK_GPIOMODE = 570544c4

[    0.144000] RALINK_GPIOMODE = 570444c4

[    0.244000] ***** Xtal 40MHz *****

[    0.248000] start PCIe register access

[    0.748000] RALINK_RSTCTRL = 2400000

[    0.752000] RALINK_CLKCFG1 = fdbfffc0

[    0.756000]

[    0.756000] *************** MT7628 PCIe RC mode *************

[    1.256000] PCIE0 enabled

[    1.260000] Port 0 N_FTS = 1b105000

[    1.264000] init_rt2880pci done

[    1.288000] bio: create slab at 0

[    1.292000] PCI host bridge to bus 0000:00

[    1.296000] pci_bus 0000:00: root bus resource [mem 0x20000000-0x2fffffff]

[    1.300000] pci_bus 0000:00: root bus resource [io  0x10160000-0x1016ffff]

[    1.304000] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]

[    1.308000] pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring

[    1.312000] pci 0000:00:00.0: BAR 0: can't assign mem (size 0x80000000)

[    1.316000] pci 0000:00:00.0: BAR 8: assigned [mem 0x20000000-0x200fffff]

[    1.320000] pci 0000:00:00.0: BAR 9: assigned [mem 0x20100000-0x201fffff pref]

[    1.324000] pci 0000:00:00.0: BAR 1: assigned [mem 0x20200000-0x2020ffff]

[    1.328000] pci 0000:01:00.0: BAR 0: assigned [mem 0x20000000-0x200fffff 64bit]

[    1.332000] pci 0000:01:00.0: BAR 6: assigned [mem 0x20100000-0x2010ffff pref]

[    1.336000] pci 0000:00:00.0: PCI bridge to [bus 01]

[    1.340000] pci 0000:00:00.0:   bridge window [mem 0x20000000-0x200fffff]

[    1.344000] pci 0000:00:00.0:   bridge window [mem 0x20100000-0x201fffff pref]

[    1.348000] BAR0 at slot 0 = 0

[    1.352000] bus=0x0, slot = 0x0

[    1.356000] res[0]->start = 0

[    1.360000] res[0]->end = 0

[    1.364000] res[1]->start = 20200000

[    1.368000] res[1]->end = 2020ffff

[    1.372000] res[2]->start = 0

[    1.376000] res[2]->end = 0

[    1.380000] res[3]->start = 0

[    1.384000] res[3]->end = 0

[    1.388000] res[4]->start = 0

[    1.392000] res[4]->end = 0

[    1.396000] res[5]->start = 0

[    1.400000] res[5]->end = 0

[    1.404000] bus=0x1, slot = 0x0

[    1.408000] res[0]->start = 20000000

[    1.412000] res[0]->end = 200fffff

[    1.416000] res[1]->start = 0

[    1.420000] res[1]->end = 0

[    1.424000] res[2]->start = 0

[    1.428000] res[2]->end = 0

[    1.432000] res[3]->start = 0

[    1.436000] res[3]->end = 0

[    1.440000] res[4]->start = 0

[    1.444000] res[4]->end = 0

[    1.448000] res[5]->start = 0

[    1.452000] res[5]->end = 0

[    1.456000] cfg80211: Calling CRDA to update world regulatory domain

[    1.460000] Switching to clocksource MIPS

[    1.464000] NET: Registered protocol family 2

[    1.476000] TCP established hash table entries: 512 (order: 0, 4096 bytes)

[    1.488000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)

[    1.500000] TCP: Hash tables configured (established 512 bind 512)

[    1.512000] TCP: reno registered

[    1.520000] UDP hash table entries: 256 (order: 0, 4096 bytes)

[    1.532000] UDP-Lite hash table e