linux outgoing网络流量很高,最好用的轻量级Linux网络流量实时监控工具nload

个人觉得nload是个很好用的轻量级Linux网络流量实时监控工具，功能也很强.安装软件后，输入命令nload后，nload软件会很直观的显示流量的即时状态，上半部分ncoming是进入网卡的流量，下半部分Outgoing是从这块网卡出去的流量，每部分都有当前流量(Curr)、平均流量(Avg)、最小流量(Min)、最大流量(Max)、总流量(Ttl)。nload的工作界面如下所示：

官网及下载：

源码包方式安装：

wget http://www.roland-riegel.de/nload/nload-0.7.4.tar.gz

tar -zxvf nload-0.7.4.tar.gz

cd nload-0.7.4

./configure;make;make install

yum方式安装：

yum install -y nload

使用：

直接输入nload回车即可，也可以指定网卡，如nload eth1，还可以指定是以K、M和G来显示流量，如nload -u M显示的流量是以MB为单位的，nload -u G显示的流量是以GB为单位的。

查看还有哪些参数或选项：

[root@wdlinux ~]# nload -h

nload version 0.7.4

Copyright (C) 2001 – 2012 by Roland Riegel <>

nload comes with ABSOLUTELY NO WARRANTY. This is free software, and you are

welcome to redistribute it under certain conditions. For more details see the

GNU General Public License Version 2 ().

Command line syntax:

nload [options] [devices]

nload –help|-h

Options:

-a period Sets the length in seconds of the time window for average

calculation.

Default is 300.

-i max_scaling Specifies the 100% mark in kBit/s of the graph indicating the

incoming bandwidth usage. Ignored if max_scaling is 0 or the

switch -m is given.

Default is 10240.

-m Show multiple devices at a time; no traffic graphs.

-o max_scaling Same as -i but for the graph indicating the outgoing bandwidth

usage.

Default is 10240.

-t interval Determines the refresh interval of the display in milliseconds.

Default is 500.

-u h|b|k|m|g Sets the type of unit used for the display of traffic numbers.

H|B|K|M|G h: auto, b: Bit/s, k: kBit/s, m: MBit/s etc.

H: auto, B: Byte/s, K: kByte/s, M: MByte/s etc.

Default is h.

-U h|b|k|m|g Same as -u, but for a total amount of data (without “/s”).

H|B|K|M|G Default is H.

devices Network devices to use.

Default is to use all auto-detected devices.

–help

-h Print this help.

example: nload -t 200 -i 1024 -o 128 -U M

The options above can also be changed at run time by pressing the ‘F2′ key.

FAQ

如安装时提示下面的问题

configure: error: ncurses library or development files not found. ncurses is required for nload.

make: *** No targets specified and no makefile found. Stop.

make: *** No rule to make target `install’. Stop.

用 yum install -y ncurses-devel 即可解决