linux eth hotplug,ifplugd检测eth0拔插消息

为了检测固定网线口的拔插消息，在busybox里配置了ifplugd

ptions:

-n              Don't daemonize

-s              Don't log to syslog

-i IFACE        Interface

-f/-F           Treat link detection error as link down/link up

(otherwise exit on error)

-a              Don't up interface at each link probe

-M              Monitor creation/destruction of interface

(otherwise it must exist)

-r PROG         Script to run

-x ARG          Extra argument for script

-I              Don't exit on nonzero exit code from script

-p              Don't run script on daemon startup

-q              Don't run script on daemon quit

-l              Run script on startup even if no cable is detected

-t SECS         Poll time in seconds

-u SECS         Delay before running script after link up

-d SECS         Delay after link down

-m MODE         API mode (mii, priv, ethtool, wlan, iff, auto)

-k              Kill running daemon

系统起来后运行ifplugd -nI -i eth0 -r /etc/network/if.sh会在当前shell启动ifplugd并检测网口状态

# ifplugd -nI -i eth0 -r /etc/network/if.sh

ifplugd(eth0): started: BusyBox v1.16.1 (2011-01-28 11:42:48 HKT)

ifplugd(eth0): using SIOCETHTOOL detection mode

ifplugd(eth0): link is up

ifplugd(eth0): executing '/etc/network/if.sh eth0 up'

ifplugd(eth0): exit code: 0

GMAC:eth0: Link is down

ifplugd(eth0): link is down

ifplugd(eth0): executing '/etc/network/if.sh eth0 down'

ifplugd(eth0): exit code: 0

GMAC:eth0 : Link is Up

ifplugd(eth0): link is up

ifplugd(eth0): executing '/etc/network/if.sh eth0 up'

ifplugd(eth0): exit code: 0

去掉-n会以daemon方式后台运行。