linux自动扩盘,自动扩容失败时如何手动扩容Linux系统盘

执行以下命令，进行扩容操作，根据提示选择对应选项。

fdisk -u /dev/vda

系统显示类似如下，保存分区信息时，会出现警告信息，由于系统盘分区是busy状态，重新读取分区表会失败。

Welcome to fdisk (util-linux 2.23.2).

Changes will remain in memory only, until you decide to write them.

Be careful before using the write command.

Command (m for help): p

Disk /dev/vda: 47.2 GB, 47244640256 bytes, 92274688 sectors

Units = sectors of 1 * 512 = 512 bytes

Sector size (logical/physical): 512 bytes / 512 bytes

I/O size (minimum/optimal): 512 bytes / 512 bytes

Disk label type: dos

Disk identifier: 0x0008d73a

Device Boot      Start         End      Blocks   Id  System

/dev/vda1   *        2048    83884031    41940992   83  Linux

Command (m for help): d

Selected partition 1

Partition 1 is deleted

Command (m for help): n

Partition type:

p   primary (0 primary, 0 extended, 4 free)

e   extended

Select (default p): p

Partition number (1-4, default 1): 1

First sector (2048-92274687, default 2048):

Using default value 2048

Last sector, +sectors or +size{K,M,G} (2048-92274687, default 92274687):

Using default value 92274687

Partition 1 of type Linux and of size 44 GiB is set

Command (m for help): wq

The partition table has been altered!

Calling ioctl() to re-read partition table.

WARNING: Re-reading the partition table failed with error 16: Device or resource busy.

The kernel still uses the old table. The new table will be used at

the next reboot or after you run partprobe(8) or kpartx(8)

Syncing disks.