交换机启用光口命令_cisco交换机通过命令行查看光纤接口类型

今天领导安排,去楼层查看下cisco 3550设备光口是什么类型,到了楼层用show int g0/1把信息拷贝回来,仔细阅读后发现红色标记的地方正式光纤的类型.在网上查询后得知SX是多摸光纤传输<10公里．LX和LH是单摸光纤,LX传输距离进<25公里,LH传输距离远<70公里.也不知道自己理解是否正确,希望大家给予指正.

Hardware is Gigabit Ethernet, address is 0007.8549.d0d9 (bia 0007.8549.d0d9)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Auto-duplex (Full), 1000Mb/s, media type is LX

output flow-control is off, input flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:03, output hang never

Last clearing of "show interface" counters never

Queueing strategy: fifo

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 2527000 bits/sec, 533 packets/sec

5 minute output rate 2652000 bits/sec, 505 packets/sec

38040353 packets input, 3467203172 bytes, 0 no buffer

Received 2032203 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 1331313 multicast, 0 pause input

639397853 packets output, 1844415782 bytes, 0 underruns

0 output errors, 0 collisions, 4 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 pause output

0 output buffer failures, 0 output buffers swapped out

====================================================================