NXOpen.UF.UFSession theUfSession = NXOpen.UF.UFSession.GetUFSession();
try
{
//初始化
NXOpen.UF.UFClone.OperationClass operationClass = NXOpen.UF.UFClone.OperationClass.CloneOperation;
theUfSession.Clone.Initialise(operationClass);
//添加原装配到克隆装配中,有Add Assembly和Add Part两种方法,此处用Add Assembly
NXOpen.UF.UFPart.LoadStatus loadStatus;
theUfSession.Clone.AddAssembly(selectPath,out loadStatus);
//theUfSession.Clone.AddPart(selectPath);
//指定默认的克隆方式
NXOpen.UF.UFClone.Action action = NXOpen.UF.UFClone.Action.Clone;
theUfSession.Clone.SetDefAction(action);
//指定默认文件名的方法
NXOpen.UF.UFClone.NamingTechnique namingTechnique = NXOpen.UF.UFClone.NamingTechnique.NamingRule;
theUfSession.Clone.SetDefNaming(namingTechnique);
//定义新装配的克隆命名规则
NXOpen.UF.UFClone.NameRuleDef nameRuleDef;
nameRuleDef.type = UFClone.NameRuleType.PrependString;
nameRuleDef.new_string = "M8";
nameRuleDef.base_string = ""; //在NX7.5版本以前,无需下面这句,但是NX7.5以后的版本中调用,必须添加下面这句,否则会显示克隆出错。
NXOpen.UF.UFClone.NamingFailures namingFailures;
theUfSession.Clone.InitNamingFailures(out namingFailures);
theUfSession.Clone.SetNameRule(ref nameRuleDef, ref namingFailures);
theUfSession.Clone.SetDefDirectory(@"C:\temp\");
//string outputName = "C:\\xxxxx.prt";
//theUfSession.Clone.SetNaming(selectPath, UFClone.NamingTechnique.DefaultNaming, outputName);
//theUI.NXMessageBox.Show("", NXMessageBox.DialogType.Information, namingFailures.n_failures.ToString());
theUfSession.Clone.PerformClone(ref namingFailures);
//theUfSession.Clone.Terminate();
}
catch (Exception ex1)
{
theUI.NXMessageBox.Show("Block Styler", NXMessageBox.DialogType.Error, ex1.ToString());
}
finally
{
theUfSession.Clone.Terminate();
}