linux以太网网络接口,linux – 多个以太网接口

我有两个网卡,配置如下：

eth0 Link encap:Ethernet HWaddr 00:19:d1:31:08:e8

inet addr:192.168.5.104 Bcast:192.168.5.255 Mask:255.255.255.0

inet6 addr: fe80::219:d1ff:fe31:8e8/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:4564126 errors:590 dropped:0 overruns:0 frame:329

TX packets:9707383 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:1151788275 (1.0 GiB) TX bytes:189318786 (180.5 MiB)

Interrupt:20 Memory:e0300000-e0320000

eth1 Link encap:Ethernet HWaddr 00:e0:4c:51:0d:55

inet addr:85.255.103.4 Bcast:85.255.103.255 Mask:255.255.255.0

inet6 addr: fe80::2e0:4cff:fe51:d55/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:5466 errors:0 dropped:0 overruns:0 frame:0

TX packets:499 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:518961 (506.7 KiB) TX bytes:34236 (33.4 KiB)

Interrupt:22 Base address:0x1000

lo Link encap:Local Loopback

inet addr:127.0.0.1 Mask:255.0.0.0

inet6 addr: ::1/128 Scope:Host

UP LOOPBACK RUNNING MTU:16436 Metric:1

RX packets:136 errors:0 dropped:0 overruns:0 frame:0

TX packets:136 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:0

RX bytes:15556 (15.1 KiB) TX bytes:15556 (15.1 KiB)

ip路由：

$ip route

192.168.5.0/24 dev eth0 proto kernel scope link src 192.168.5.104

85.255.103.0/24 dev eth1 proto kernel scope link src 85.255.103.4

default via 192.168.5.1 dev eth0

default via 85.255.103.1 dev eth1

当我ping eth1的ip地址时,我得不到任何回复.

使用tcpdump,我认为发送到eth1的所有ICMP回应请求都是通过eth0接口回答的.

如何实现两个接口正常工作？如果我ping eth1,它也应该返回eth1的答案.

eth0有一个更快的互联网连接,我只想保持eth1周围,并在应用程序绑定到特定的IP时通过它.