HostA和HostC属于部门A,但是通过不同的设备接入公司网络;HostB和HostB属于部门B,也通过不同的设备接入公司网络。
为了通信安全,页为了避免广播报文泛滥,公司网络中使用vlan技术来隔离部门间的二层流量。其中部门A使用vlan100,部门B使用vlan200。
现要求不管是否使用相同的设备接入公司网络,同意vlan内的主机能够互通,即HostA和HostC能够互通,HostB和HostD能够互通。
- 配置步骤
(1) 配置 Device A
# 创建VLAN 100,并将GigabitEthernet1/0/1 加入VLAN 100。
<DeviceA> system-view
[DeviceA] vlan 100
[DeviceA-vlan100] port gigabitethernet 1/0/1
[DeviceA-vlan100] quit
创建VLAN 200,并将GigabitEthernet1/0/2 加入VLAN 200。
[DeviceA] vlan 200
[DeviceA-vlan200] port gigabitethernet 1/0/2
[DeviceA-vlan200] quit
为了使Device A 上VLAN 100 和VLAN 200 的报文能发送给Device B , 将
GigabitEthernet1/0/3 的链路类型配置为Trunk,并允许VLAN 100 和VLAN 200 的报文通过。
[DeviceA] interface gigabitethernet 1/0/3
[DeviceA-GigabitEthernet1/0/3] port link-type trunk
[DeviceA-GigabitEthernet1/0/3] port trunk permit vlan 100 200
(2) Device B 上的配置与Device A 上的配置相同,不再赘述。
(3) 将Host A 和Host C 配置在一个网段,比如192.168.100.0/24;将Host B 和Host D 配置在
一个网段,比如192.168.200.0/24。**
- 验证配置
(1) Host A 和Host C 能够互相ping 通,但是均不能ping 通Host B。Host B 和Host D 能够互相
ping 通,但是均不能ping 通Host A。
(2) 通过查看显示信息验证配置是否成功。查看Device A 上VLAN 100 和VLAN 200 的配置信息,验证以上配置是否生效。
[DeviceA-Ten-GigabitEthernet1/0/3] display vlan 100
VLAN ID: 100
VLAN type: Static
Route interface: Not configured
Description: VLAN 0100
Name: VLAN 0100
Tagged ports:
Ten-GigabitEthernet1/0/3
1-13
Untagged ports:
Ten-GigabitEthernet1/0/1
[DeviceA-Ten-GigabitEthernet1/0/3] display vlan 200
VLAN ID: 200
VLAN type: Static
Route interface: Not configured
Description: VLAN 0200
Name: VLAN 0200
Tagged ports:
Ten-GigabitEthernet1/0/3
Untagged ports:
Ten-GigabitEthernet1/0/2
转载于:https://blog.51cto.com/14228563/2385848