Sample Configuration for Citrix XenServer

All versions of Citrix XenServer use a DM-Multipath configuration file, but there might be slight variations in the file based on which Citrix update you have installed.  You can replace your current file with sample file and change the values to the ones that are appropriate for your system.

Citrix XenServer, SAN boot LUNs, and user_friendly_names parameter

 

You can use the sample Citrix XenServer configuration files shown here to create your own multipath.conf file.

When you create your file, keep the following in mind:

Citrix XenServer 6 series Parameter notes
Blacklist section You must provide information of your system in the blacklist section.

Any  names shown in the sample files are examples and will not work with your system.
wwid <Dev ID> Use the actual device ID. Run  the /sbin/scsi_id -g -u -s /block/%n command on the SCSI drive to be blacklisted.
SAN boot support SAN booting is supported only with  Citrix XenServer 6 series and the FC/FCoE protocol.
SAN boot LUNs and  the user_friendly_names parameter

NetApp recommends that you set  the user_friendly_names parameter to no. There have been reports of problems when this parameter is set to  yes.

The recommended value for   the user_friendly_names parameter is no. There have been reports of problems when this parameter is set to  yes.

If you create a SAN boot LUN and the installer sets the user_friendly_names parameter to yes, you must perform the following steps.

  1. Change  the user_friendly_names parameter to