EIGRP中在T1（1.54Mbps）链路中的hello时间间隔默认为60秒

                 大于T1链路时hello的时间间隔默认为5秒

 
修改间隔的命令为：
interface s0/0
 ip hello-interval eigrp 1 2   其中1为自治域系统号，2为hello时间间隔
 ip hold-time eigrp 1 6，其中1为自治域系统号，6为保持计时器时间

 
查看修改后的配置
R1#show ip eigrp interfaces detail
IP-EIGRP interfaces for process 1

 
                        Xmit Queue   Mean   Pacing Time   Multicast    Pending
Interface        Peers  Un/Reliable  SRTT   Un/Reliable   Flow Timer   Routes
Se0/0              1        0/0       205       0/15         927           0
  Hello interval is 1 sec
  Next xmit serial <none>
  Un/reliable mcasts: 0/0  Un/reliable ucasts: 2/10
  Mcast exceptions: 0  CR packets: 0  ACKs suppressed: 4
  Retransmissions sent: 2  Out-of-sequence rcvd: 0
  Authentication mode is not set
  Use unicast

 
实验配置

 

按照上图配置好借口地址与EIGRP
1.0.0.1 --> 2.0.0.2  是通过fram-relay网络传输，

 
我们可以做如下测试将R2的s0/0接口手动shutdown后，1.0.0.1 --> 2.0.0.2 多长时间能通
测试方法
R1#ping 2.0.0.2 source loopback 0 repeat 1000 timeout 1
Type escape sequence to abort.
Sending 1000, 100-byte ICMP Echos to 2.0.0.2, timeout is 1 seconds:
Packet sent with a source address of 1.0.0.1
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!...!!!!!!!!!!!!!!!!
要求：如果要求在R2的s0/0接口shutdown后5秒内 1.0.0.1 -->2.0.0.2 能够ping通
修改方法：在R1和R2的s0/0接口上做如下配置即可
interface s0/0
 ip hello-interval eigrp 1 1
 ip hold-time eigrp 1 3
其中前面的1为EIGRP的自治域系统号