Ubuntu的超宽屏支持2560*1080,参见:
不过,没搞定。
最后,换了根4K线就自动识别了,不要用老的DSP/HDMI线和接口转换器,传输率不够。
后面这些操作都是多余的,而且没有任何效果。
操作:
openthings@openthings:~$ xrandr
Screen 0: minimum 8 x 8, current 1920 x 1080, maximum 32767 x 32767
DP-0 disconnected (normal left inverted right x axis y axis)
DP-1 connected primary 1920x1080+0+0 (normal left inverted right x axis y axis) 670mm x 280mm
1920x1080 60.00*+
1680x1050 59.95
1600x1200 60.00
1440x900 74.98 59.89
1280x1024 75.02 60.02
1280x720 60.00
1024x768 75.03 60.00
800x600 75.00 60.32
640x480 75.00 72.81 59.94
DP-2 disconnected (normal left inverted right x axis y axis)
DP-3 disconnected (normal left inverted right x axis y axis)
HDMI-0 disconnected (normal left inverted right x axis y axis)
DP-4 disconnected (normal left inverted right x axis y axis)
DP-5 disconnected (normal left inverted right x axis y axis)
计算分辨率参数:
openthings@openthings:~$ cvt 2560 1080
# 2560x1080 59.98 Hz (CVT) hsync: 67.17 kHz; pclk: 230.00 MHz
Modeline "2560x1080_60.00" 230.00 2560 2720 2992 3424 1080 1083 1093 1120 -hsync +vsync
设置:
#添加显示模式
xrandr --newmode "2560x1080_60.00" 230.00 2560 2720 2992 3424 1080 1083 1093 1120 -hsync +vsync
xrandr --addmode DP-1 "2560x1080_60.00"
出错:
openthings@openthings:~$ xrandr --addmode DP-1 "2560x1080_60.00"
X Error of failed request: BadMatch (invalid parameter attributes)
Major opcode of failed request: 140 (RANDR)
Minor opcode of failed request: 18 (RRAddOutputMode)
Serial number of failed request: 41
Current serial number in output stream: 42