Topic: ERROR:Out of Memory! Posted: January 27 2010 at 9:50am | |
HI,Everyone!
I have a big trouble!
I have a lot of 3D models in xpl format,and I add all of them to TEP uisng stream layer.
At the beginning the TEP runned smoothly,but after running for a while it turned very slowly and then appeared
out of memory error. It will be much better after I refresh the layer when TEP runned slowly.
Is TEP not automatically unload the memory Or still need to set something?
who can help me?
Each model is about 100kb ,and there are 3000 models at least.
The layer's maxvisibility is 500m
Edited by haihao - January 29 2010 at 2:25pm | |
wengel
Skyline Admin Group Joined: June 08 2007 Location: United States Status: Offline Points: 39 | Post Options
|
Hi, How is your SHP file configured? Is your block width set to Auto? Also, what is your maximum streaming altitude? About the objects themselves, what is the setting for "Best LOD Size"? When you created these XPLs, did you use MakeXPL.exe that comes with the Pro install? If so, how did you set these to be built? Looking forward to your reply.
-Wilson | |
wengel
Skyline Admin Group Joined: June 08 2007 Location: United States Status: Offline Points: 39 | Post Options
|
One other thing -- is your graphics card's driver is up to date? Also-- can you provide the specs on it? Is it shared memory or dedicated card?
-Wilson
| |
haihao
Visitor Joined: February 19 2009 Status: Offline Points: 8 | Post Options
|
Hi,Wilson!
Thank you for your reply!
My block width is 512m,It's very small.
Maximum streaming altitude is 700m,It's very low.
"Best LOD Size" is 1000m.It's default.
I used "MakeXpl.exe" to create xpls,and most of the xpls have three levels.
My NoteBook: Graphics card is GF 9600GT;OS is winXPSP3;
Memory is 2G,CPU is T6600.
I want to know if the model created in memory is not automatically unload?
By the way my TEP vision is 5.1.0.f23
by haihao
Edited by haihao - January 29 2010 at 2:26pm | |
wengel
Skyline Admin Group Joined: June 08 2007 Location: United States Status: Offline Points: 39 | Post Options
|
Thanks for the reply. Your setup seems OK, but what about the driver date? It's a good idea to check the NVidia website for a new driver. Are other machines showing this problem too? At 700m maximum streaming altitude, you're probably seeing pretty high resolution just as the buildings are starting to stream in. Is that right? Without seeing the project or screenshots, best advice is to adjust LOD up to 1200. Can you post/email the fly file or screenshots? I'd also recommend you upgrade to the latest TEPro if that's possible.
|
ERROR:Out of Memory!
最新推荐文章于 2023-10-17 16:15:31 发布