Hub and Spoke

本文出自Simmy的个人blog：西米在线   http://simmyonline.com/archives/542.html

 

The Enhanced Interior Gateway Routing Protocol (EIGRP) Stub Routing feature
improves network stability, reduces resource utilization, and simplifies stub router
configuration.

 

Stub routing is commonly used in a hub and spoke network topology. In a hub and spoke
network, one or more end (stub) networks are connected to a remote router (the spoke)
that is connected to one or more distribution routers (the hub). The remote router is
adjacent only to one or more distribution routers. The only route for IP traffic to follow
into the remote router is through a distribution router. This type of configuration is
commonly used in WAN topologies where the distribution router is directly connected to
a WAN. The distribution router can be connected to many more remote routers. Often,
the distribution router will be connected to 100 or more remote routers. In a hub and
spoke topology, the remote router must forward all nonlocal traffic to a distribution
router, so it becomes unnecessary for the remote router to hold a complete routing table.

Generally, the distribution router need not send anything more than a default route to the
remote router.

When using the EIGRP Stub Routing feature, you need to configure the distribution and
remote routers to use EIGRP, and to configure only the remote router as a stub. Only
specified routes are propagated from the remote (stub) router. The router responds to
queries for summaries, connected routes, redistributed static routes, external routes, and
internal routes with the message "inaccessible." A router that is configured as a stub will
send a special peer information packet to all neighboring routers to report its status as a
stub router.

本文转simmy51CTO博客，原文链接：http://blog.51cto.com/helpdesk/187889 ，如需转载请自行联系原作者