AutoCAD
凸度的计算
AutoCAD
中凸度的概念以及求圆弧的凸度
The bulge factor is used to indicate how much of an arc se
gment is present at this vertex. The bulge factor is the t
angent of one fourth the included angle for an arc segment,
made negative if the arc goes clockwise from the start po
int to the endpoint. A bulge of 0 indicates a straight seg
ment, and a bulge of 1 is a semicircle.
凸度被用来表示一个顶点的弧度大小,
它的值是这段弧所包含角度的
1/4
角度的正切。如果弧从起点到终点是顺时针走向则凸度为负数,
0
表示直线,
1
表示半圆。
在将圆弧转化为多段线
(AcDbPolyLine)
时,
需要计算圆弧的凸度。
在
AutoCAD
中规定,圆弧的走向始终是逆时针走向,所以终点角度应大
小起点角度(以圆心为原点中,以
X
轴正方向为
0
,逆时针旋转为正