计算机组成 quia,钢筋砼不等肢异形柱的延性性能分析研究-结构工程专业论文.docx...-CSDN博客

钢筋砼不等肢异形柱的延性性能分析研究-结构工程专业论文

摘要钢筋砼异形柱结构体系在居住建筑中的应用越来越广泛，但目前对等肢异形

摘要

钢筋砼异形柱结构体系在居住建筑中的应用越来越广泛，但目前对等肢异形柱的研究较多，而对不等肢异形柱的研究较少，尤其对其延性性能的研究更少。本文采用全过程非线性分析方法，对钢筋砼不等肢L、T、+形截面异形柱的延性性能进行了较全面的研究，主要研究内容和成果如下：

1．建立了分析不等肢异形柱延性性能的方法，采用Visual c++编制了不等肢异形柱延性性能非线性分析程序SCDP，程序计算结果与试验结果的比较验证了本文分析方法和程序的正确性。

2．应用SCDP程序对275根不等肢L形异形柱、243根不等肢T形异形柱和223根不等肢+形异形柱进行了计算分析，研究了荷载角、轴压比、箍筋间距、截面肢长等因素对不等肢异形柱截面延性性能的影响，褥到了其延性变化规律。 3．考虑到地震作用的往复性，采用平均位移延性比对不等肢异形截面框架柱的延性性能进行了分析。建立了平均位移延性比与截面曲率延性比之间的转换

关系，分析了二者之间的差异。 4，对不等肢L、T、+形截面异形柱和等肢异形柱的延性性能进行了对比分

析，计算结果表明，对于L形截面，两者的延性性能较为接近；而对于T、+形截面，不等肢异形柱较等肢异形柱的延性性能有一定的降低。

5．在上述计算分析的基础上，对不等肢异形柱位移延性比的计算结果采用最小二乘法进行了回归分析，提出了简化的位移延性比计算公式，并给出了不等肢异形柱的轴压比限值的建议值。

本文的研究成果不仅可为实际工程设计提供参考，而且可为完善相关的技术标准提供理论依据。

关键词：不等肢异形柱，延性，曲率延性比，位移延性比，轴压比限值

ABSTRACTThe

ABSTRACT

The R．C．frame structures with special—shaped columns were used more widely in the housing buildings，and there are many researches on the equiaxial special—shaped columns，while there is little research on the inequiaxial special—shaped

columns，especially on the ductility of the inequiaxial special-shaped columns．The

ductility of the R．C．inequiaxial L-shaped、T·shaped and+-shaped columns were

detailed researched with the method of full—range nonlinear analysis in this dissertation，the chiefcontents and achievements are shown as follows：

1．A method for analysis of the inequiaxial special—shaped columns is established．The computer program(SCDP)for analysis of the ductility of the special-shaped columns was compiled in Visual C++surroundings．Comparison in

theoretical resuRs calculated by the SCDP program with experimental results WaS made and the resuRs obtained show the correctness and applicability ofthe sot'CWare．

2．275 sets of inequiaxial L—shaped columns、243 sets of inequiaxial T—shaped columns and 223 sets of inequiaxial+一shaped columns were calculated by the SCDP program．Many relevant factors including angles ofloading、axial foree ratio、spacing

of lateral reinforcement and change of section for the ductility of the inequiaxial

special—sha