【centos】新安装的centos报错:could not resolve host: mirrorlist.centos.org,centos 无法连接网络

问题:centos 7.5安装完之后无法连接网络,使用yum无法正常安装软件,报错could not resolve host: mirrorlist.centos.org等。(虚拟机安装或实体主机安装)

Could not retrieve mirrorlist http://mirrorlist.centos.org/?release=7&arch=x86_64&repo=os&infra=stock error was
14: curl#6 - "Could not resolve host: mirrorlist.centos.org; Unknown error"

 One of the configured repositories failed (Unknown),
 and yum doesn't have enough cached data to continue. At this point the only
 safe thing yum can do is fail. There are a few ways to work "fix" this:

     1. Contact the upstream for the repository and get them to fix the problem.

     2. Reconfigure the baseurl/etc. for the repository, to point to a working
        upstream. This is most often useful if you are using a newer
        distribution release than is supported by the repository (and the
        packages for the previous distribution release still work).

     3. Disable the repository, so yum won't use it by default. Yum will then
        just ignore the repository until you permanently enable it again or use
        --enablerepo for temporary usage:

            yum-config-manager --disable <repoid>

     4. Configure the failing repository to be skipped, if it is unavailable.
        Note that yum will try to contact the repo. when it runs most commands,
        so will have to try and fail each time (and thus. yum will be be much
        slower). If it is a very temporary problem though, this is often a nice

            yum-config-manager --save --setopt=<repoid>.skip_if_unavailable=true

Cannot find a valid baseurl for repo: base/7/x86_64

这些报错其实意思就是你的centos系统网络不通,不相信可以使用命令 ping 测试。

进入网卡配置文件所在目录:# cd /etc/sysconfig/network-scripts/
编辑网卡配置文件(下图红框中的文件):# vi ifcfg-ens33 (不用系统可能文件名不一样)

将文件中的最后一行的ONBOOT=no 改为ONBOOT=yes,如下图

保存文件并退出vi,重启network:# service network restart

版权声明:本文为CSDN博主「Steve_Stone」的原创文章,遵循CC 4.0 by-sa版权协议,转载请附上原文出处链接及本声明。

©️2020 CSDN 皮肤主题: 大白 设计师:CSDN官方博客 返回首页