进入端口配置模式光
输入下面的隐藏命令(不能按键)
第一条命令:
CISCO(config)#service unsupported-transceiver
输入上面的命令后会输出以下log:
Warning光 When Cisco determines that a fault or defect can be traced to the use of third-party transceivers installed by a customer or reseller, then, at Cisco’s discretion, Cisco may withhold support under warranty or a Cisco support program. In the course of providing support for a Cisco networking product Cisco may require that the end user install Cisco transceivers if Cisco determines that removing third-party parts will assist Cisco in diagnosing the cause of a support issue.
第二条命令:
CISCO(config)#no errdisable detect cause gbic-invalid
第三条命令:
CISCO(config)#speed nonegotiate
保存配置
然后插上光模块
完成
破解后思科就不会去检查 GBIC的序号,而让使用者可以把第三方的 GBIC 或SFP 插在机器上,让网络先恢复运作。
执行第三条命令:speed nonegotiate #取消自动协商协议
没有成功。
注意步骤:1.执行命令前,拔出G 7/22光模块;
2.执行结束后,插入光模块,直接no shutdown 依然不亮;
3.先shutdown,再no shutdown;
至此,正常通信,happy~