IAR EW8051-8.1编译ZStack时，出现警告Warning[Pe069]: integer conversion resulted in truncation的解决办法

1. 首先，打开"C:\Texas Instruments\ZStack-CC2530-2.3.0-1.4.0\Components\hal\target\CC2530EB\hal_dma.h"；
2. 找到“hal_dma.h”文件中的一段代码，如下所示：

/*********************************************************************
 * MACROS
 */

#define HAL_DMA_SET_ADDR_DESC0( a ) \
  st( \
    DMA0CFGH = (uint8)( (uint16)(a) >> 8 );  \
    DMA0CFGL = (uint8)( (uint16)(a)&0x00ff);       \
  )

#define HAL_DMA_SET_ADDR_DESC1234( a ) \
  st( \
    DMA1CFGH = (uint8)( (uint16)(a) >> 8 );  \
    DMA1CFGL = (uint8)( (uint16)(a)&0x00ff);       \
  )

#define HAL_DMA_GET_DESC0()           &dmaCh0

#define HAL_DMA_GET_DESC1234( a )     (dmaCh1234+((a)-1))

#define HAL_DMA_ARM_CH( ch )           DMAARM = (0x01 << (ch))

#define HAL_DMA_CH_ARMED( ch )        (DMAARM & (0x01 << (ch)))

#define HAL_DMA_ABORT_CH( ch )         DMAARM = (0x80 | (0x01 << (ch)))
#define HAL_DMA_MAN_TRIGGER( ch )      DMAREQ = (0x01 << (ch))
#define HAL_DMA_START_CH( ch )         HAL_DMA_MAN_TRIGGER( (ch) )

#define HAL_DMA_CLEAR_IRQ( ch )        DMAIRQ &= ~( 1 << (ch) )

#define HAL_DMA_CHECK_IRQ( ch )       (DMAIRQ & ( 1 << (ch) ))

// Macro for quickly setting the source address of a DMA structure.
#define HAL_DMA_SET_SOURCE( pDesc, src ) \
  st( \
    pDesc->srcAddrH = (uint8)((uint16)(src) >> 8); \
    pDesc->srcAddrL = (uint8)((uint16)(src) & 0x00ff); \
  )

// Macro for quickly setting the destination address of a DMA structure.
#define HAL_DMA_SET_DEST( pDesc, dst ) \
  st( \
    pDesc->dstAddrH = (uint8)((uint16)(dst) >> 8); \
    pDesc->dstAddrL = (uint8)((uint16)(dst) & 0x00ff); \
  )

• 将你的“hal_dma.h”文件中的这行代码按照以上代码进行修改，然后保存并编译，会发现该警告已消除。