HWIC-4ESW插在同一台路由器上,并配置VLAN的话,一定要用两块卡中的一端口进行堆叠,否则除VLAN1之外,其它VLAN无法通信。
配置方法:
Configuring Stacking
Stacking is the connection of two switch modules resident in the same chassis so that they behave as a single switch. When a chassis is populated with two switch modules, the user must configure both of them to operate in stacked mode. This is done by selecting one port from each switch module and configuring it to be a stacking partner. The user must then connect with a cable the stacking partners from each switch module to physically stack the switch modules. Any one port in a switch module can be designated as the stacking partner for that switch module.
Beginning in privileged EXEC mode, follow these steps to configure a pair of ports on two different switch modules as stacking partners.
SUMMARY STEPS
1.
fastethernetinterface-id
2.
no shutdown
3.
switchport stacking-partner interface FastEthernetpartner-interface-id
4.
exit
5.
interfacefastethernetpartner-interface-id
6.
no shutdown
7.
end
DETAILED STEPS
Command
Purpose
Step 1
Router(config)#interface fastethernet
interface-id
Selects the interface to configure.
Step 2
Router(config-if)#no shutdown
Activates the interface. (Required only if you shut down the interface.)
Step 3
Router(config-if)#switchport
stacking-partner interface FastEthernetpartner-interface-id
Selects and configures the stacking partner port.
Step 4
Router(config-if)#exit
Exits interface configuration mode.
Step 5
Router(config)#interface fastethernet
partner-interface-id
Selects the stacking partner interface.
Step 6
Router(config-if)#no shutdown
Activates the stacking partner interface.
Step 7
Router(config-if)#end
Exits configuration mode.