本帖最后由 zyyjcj 于 2015-2-27 20:13 编辑
想必大家R7000到手后都发现没有无线MAC过滤功能,对于平时不加密或作为AP的人来说很不方便,其实这个功能只是被隐藏了而已。
游览器登陆:http://routerlogin.net/WLG_acl.htm
发现了么:)
QQ截图20150227200716.png (92.82 KB, 下载次数: 11)
2015-2-27 20:07 上传
Wireless Card Access List Help
By default, any wireless PC that is configured with the correct SSID will be allowed access to your wireless network. For increased security, you can restrict access to the wireless network to allow only specific PCs based on their MAC addresses.The Wireless Card Access Setup screen displays a list of wireless PCs that will be allowed to connect to the router based on their MAC addresses. These wireless PCs must also have the correct SSID and WEP settings configured on the Wireless Settings screen to access the wireless network.
Turn Access Control On
1. Select the Turn Access Control On check box to enable the restricting of wireless PCs by their MAC addresses.
2. Click the Apply button to save changes and return to the Wireless Settings screen.
Note: If Turn Access Control On is enabled and the Access Control List is blank, then all wireless PCs will be unable to connect to your wireless network.
To Set Up the Access Control List1. Click the Add button to go to the Access Setup screen. For your convenience, this screen displays a list of currently active wireless cards and their Ethernet MAC addresses.2. If the PC you want appears in the list, you can click the radio button of that PC to capture its MAC address; otherwise, you can manually enter the MAC address of the authorized PC. The MAC address can usually be found on the bottom of the wireless device.3. If no device name appears, you can type a descriptive name for the PC that you are adding.4. When you have finished entering the MAC address, return to the Wireless Access List screen by clicking the Add button.
Note: Repeat steps 1 through 4 for each wireless PC.5. Select the Turn Access Control On check box to enable access control.6. Click the Apply button to save changes and return to the Wireless Settings screen. To Edit a Wireless PC on the Access Control List: 1. Select the radio button of the wireless PC you wish to edit.
2. Click the Edit button.
3. Edit the device name or MAC address.
4. Click the Accept button when finished.
5. Click the Apply button to save changes and return to the Wireless Settings screen.To Delete a PC on the Access Control List: 1. Click the radio button of the wireless PC you wish to delete.
2. Click the Delete button.
3. Click the Apply button to save changes and return to the Wireless Settings screen.
To save or cancel changes:
Click Apply when you finish changing the settings.
Click Cancel to return to the previous settings.