stm32不使用外部晶振管脚怎么处理_stm32103如果不用32k晶振，那引脚是悬空还是接地？...

如果使用内部RC振荡器而不使用外部晶振，请按照下面方法处理：

1)对于100脚或144脚的产品，OSC_IN应接地，OSC_OUT应悬空。

2)对于少于100脚的产品，有2种接法：

2.1)OSC_IN和OSC_OUT分别通过10K电阻接地。此方法可提高EMC性能。

2.2)分别重映射OSC_IN和OSC_OUT至PD0和PD1，再配置PD0和PD1为推挽输出并输出'0'。此方法可以减小功耗并(相对上面2.1)节省2个外部电阻。

--------------------------------------------------------------------------------

以下是在ST英文网站FAQ上抄下的详细解释：

1)  In 100 and 144 packages,  the OSC_IN /OSC_Out pins are a dedicated pins for HSE and mapped respectively on pins 12, 13 and pins 23, 24 for LQFP packages. Although, for BGA 100 and BGA 144 packages, they are mapped respectively on pins C1,D1 and pins D1,E1. In this case the recommended configuration is:

OSC_In pin must be connected to ground as it is always an input pin

OSC_Out must be left not connected as it is always an output pin.

2)  In LQFP48 and LQFP64 packages,  the OSC_IN/O