linux7改网卡名eth,CentOS7修改网卡名称为eth开头的方法

1.系统安装时修改

系统引导菜单出现，将光标移动到“Install CentOS 7”时，按“Tab”键，然后在“quiet”后面输入“net.ifnames=0 biosdevname=0”，然后回车键继续安装，安装完成之后网卡就是eth开头(注意quiet后面有空格)

2.现有系统修改

2.1.修改配置文件

[root@itbkz ~]#mv /etc/sysconfig/network-scripts/{ifcfg-ens192,ifcfg-eth0}

[root@itbkz ~]#sed 's/ens192/eth0/' /etc/sysconfig/network-scripts/ifcfg-eth0 -i

请注意将ens192替换为自己网卡的名称

2.2.GRUB添加kernel参数

[root@itbkz ~]#echo 'GRUB_CMDLINE_LINUX="...net.ifnames=0 biosdevname=0 quiet"' >>/etc/sysconfig/grub

2.3.刷新至grub配置文件

[root@itbkz ~]#grub2-mkconfig -o /boot/grub2/grub.cfg

Generating grub configuration file ...

Found linux image: /boot/vmlinuz-3.10.0-957.el7.x86_64

Found initrd image: /boot/initramfs-3.10.0-957.el7.x86_64.img

Found linux image: /boot/vmlinuz-0-rescue-4e7ec2a4b5244a1dac8357126dabf8fb

Found initrd image: /boot/initramfs-0-rescue-4e7ec2a4b5244a1dac8357126dabf8fb.img

done

2.4.重启系统生效

[root@itbkz ~]#init 6

[root@itbkz ~]#ifconfig eth0

eth0: flags=4163 mtu 1500

inet 192.168.1.246 netmask 255.255.255.0 broadcast 192.168.1.255

inet6 fe80::a9a9:2149:4104:8b78 prefixlen 64 scopeid 0x20

ether 00:0c:29:c7:3a:6e txqueuelen 1000 (Ethernet)

RX packets 609 bytes 41910 (40.9 KiB)

RX errors 0 dropped 484 overruns 0 frame 0

TX packets 116 bytes 13554 (13.2 KiB)

TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

2.5.查看grub.cfg配置文件

IT博客站版权所有丨如未注明 , 均为原创丨本网站采用BY-NC-SA协议进行授权

转载请注明原文链接：CentOS7修改网卡名称为eth开头的方法