stm32 串口2空闲中断死机_stm32f407串口空闲中断

void GPRSusart1_init(u32 Boun)

{

//GPIO端口设置

GPIO_InitTypeDef GPIO_InitStructure;

USART_InitTypeDef USART_InitStructure;

NVIC_InitTypeDef NVIC_InitStructure;

RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOA,ENABLE); //使能GPIOA时钟

RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1,ENABLE);//使能USART1时钟

//串口1对应引脚复用映射

GPIO_PinAFConfig(GPIOA,GPIO_PinSource9,GPIO_AF_USART1); //GPIOA9复用为USART1

GPIO_PinAFConfig(GPIOA,GPIO_PinSource10,GPIO_AF_USART1); //GPIOA10复用为USART1

//USART1端口配置

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9 | GPIO_Pin_10; //GPIOA9与GPIOA10

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF;//复用功能

GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;        //速度50MHz

GPIO_InitStructure.GPIO_OType = GPIO_OType_PP; //推挽复用输出

GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP; //上拉

GPIO_Init(GPIOA,&GPIO_InitStructure); //初始化PA9，PA10

//USART1 初始化设置

USART_InitStructure.USART_BaudRate = Boun;//波特率设置

USART_InitStructure.USART_WordLength = USART_WordLength_8b;//字长为8位数据格式

USART_InitStructure.USART_StopBits = USART_StopBits_1;//一个停止位

USART_InitStructure.USART_Parity = USART_Parity_No;//无奇偶校验位

USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;//无硬件数据流控制

USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;        //收发模式

USART_Init(USART1, &USART_InitStructure); //初始化串口1

USART_Cmd(USART1, ENABLE);  //使能串口1

USART_ClearFlag