linux centos7如何安装软件,Linux（CentOS7.x）学习笔记（七）软件安装

原始码安装

tarball安装

安装软件：ntp(network time protocol)时间服务器

-1--下载ntp tar.gz包----------------------------------------------------------------------

[root@localhost ~]# wget http://www.eecis.udel.edu/~ntp/ntp_spool/ntp4/ntp-4.2/ntp-4.2.8p13.tar.gz

[root@localhost ~]# ls

anaconda-ks.cfg CentOS7.7 link.prac myProject ntp-4.2.8p13.tar.gz

-2--将下载的包解压到 /usr/local/src/-------------------------------------------------------

[root@localhost ~]# cd /usr/local/src/

[root@localhost src]# pwd

/usr/local/src

[root@localhost src]# tar -zxvf /root/ntp-4.2.8p13.tar.gz

.............此处省略

ntp-4.2.8p13/lib/isc/ia64/include/

ntp-4.2.8p13/lib/isc/ia64/include/isc/

ntp-4.2.8p13/lib/isc/ia64/include/isc/atomic.h

ntp-4.2.8p13/lib/isc/nls/msgcat.c

[root@localhost src]# ls

ntp-4.2.8p13

-3--建立makefile，配置其安装目录为/usr/local/ntp----------------------------------

[root@localhost src]# cd ntp-4.2.8p13/

[root@localhost ntp-4.2.8p13]# vim INSTALL <==查看INSTALL，在28行到54行之间的安装简介，可以了解如何安装的流程。

[root@localhost ntp-4.2.8p13]# ./configure --prefix=/usr/local/ntp --enable-all-clocks --enable-parse-clocks

config.status: creating evconfig-private.h

config.status: evconfig-private.h is unchanged

config.status: executing depfiles commands

config.status: executing libtool commands

-4--编译与安装--------------------------------------------------------------------

[root@localhost ntp-4.2.8p13]#make clean；make

[root@localhost ntp-4.2.8p13]#make check

[root@localhost ntp-4.2.8p13]#make install