单片机c语言显示字母,单片机C语言编程：按键、计数及显示

应网友要求，下面写一个用C语言编写的程序。

电路中，共使用了三个按键，两位数码显示。使用12MHz或11.0592MHz的晶振皆可。

用Proteus仿真运行后截图如下：

程序如下：

//===================================================

#include#define uint unsigned int

#define uchar unsigned char

sbit ADD_1 = P3^2;

sbit SUB_1 = P3^3;

sbit RST_0 = P3^4;

uchar num;

uchar code DIS_SEG7[]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90};

//---------------------------------------------------

void delay(uint ms)

{

uint i, j;

for(i = ms; i > 0; i--) for(j = 110; j > 0; j--);

}

//---------------------------------------------------

void display(uchar num)

{

P2 = 0;                     //消隐

P0 = DIS_SEG7[num / 10];    //输出段码

P2 = 2;                     //显示位置

delay(3);                   //显约3ms

P2 = 0;

P0 = DIS_SEG7[num % 10];

P2 = 1;

delay(3);

}

//---------------------------------------------------

void main()

{

num = 0;

while(1) {                  //主循环

display(num);             //显示

if (ADD_1 == 0) {        //如果有键按下

display(num);           //用显示代替延时

if (ADD_1 == 0) {      //如果键还在按下

num++;                //按键功能处理

if (num >= 100) num = 0;

while(ADD_1 == 0) display(num); //等待按键释放

}

}

if (SUB_1 == 0) {

display(num);

if (SUB_1 == 0) {

num--;

if (num == -1) num = 99;

while(SUB_1 == 0) display(num);

}

}

if (RST_0 == 0) {

display(num);

if (RST_0 == 0) num = 0;

while(RST_0 == 0) display(num);

}

}   }

//===================================================