JMeter 的配置中，5个用户应在1小时内执行1万个请求，但实际执行时用户在1秒内完成。调整建议包括将Ramp-Up Period设置为1，Loop Count设为Forever，并使用Constant Throughput Timer设定目标吞吐量为166.6666666667，以确保请求均匀分布。另外，推荐使用Ultimate Thread Group进行更易配置的负载测试。
Jmeter: We have a scenario where 5 users should trigger 10 thousand requests in 1 hour, to achieve this below configurations have been done.
Thread group - users - 5; ramp up - 3600 (secs); loop count - 1
Loop controller value: 10000
Request is under this Loop Controller
When executed the above scenario, Jmeter is executing/triggering 5 users in 1 second only.
Are these configurations correct to achieve our scenario load testing output.
Please suggest and guide.
解决方案
Your configuration is a little bit incorrect. In your setup
JMeter will start with one user which will execute 10 000 requests as fast as it can
In 12 minutes another user will start and execute 10 000 requests as fast as it can
In 12 minutes another user will start and execute 10 000 requests as fast as it can
etc.
You will not
最低0.47元/天 解锁文章
扫一扫
375
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
