手工模式链路聚合 + LACP模式链路聚合配置

手工模式链路聚合

sy
Enter system view, return user view with Ctrl+Z.
[Huawei]sysna
[Huawei]sysname SW1
[SW1]int Eth-Trunk 1
[SW1-Eth-Trunk1]trunkport GigabitEthernet 0/0/1 to g0/0/3
[SW1-Eth-Trunk1]port link-type trunk
[SW1-Eth-Trunk1]port trunk allow-pass vlan 10 20

sy
Enter system view, return user view with Ctrl+Z.
[Huawei]sysna
[Huawei]sysname SW2
[SW2]int Eth-Trunk 1
[SW2-Eth-Trunk1]trunkport GigabitEthernet 0/0/1 to g0/0/3
[SW2-Eth-Trunk1]port link-type trunk
[SW2-Eth-Trunk1]port trunk allow-pass vlan 10 20

LACP模式链路聚合配置

sys
sysname S1 #更改设备名S1
lacp priority 100 #lacp优先级100
interface Eth-Trunk1 #接口Eth-1
mode lacp #模式lacp
trunkport GigabitEthernet 0/0/1 to 0/0/3 #批量端口加入接口Eth-1
port link-type trunk #端口链路型中继
port trunk allow-pass vlan 10 20 #端口中继允许通过vlan 10 20
least active-linknumber 2 #最小活动链接数2
load-balance dst-ip #负载平衡dst ip
lacp preempt enable #lacp抢占启用
max active-linknumber 2 #最大活动链接数2

sys
sysname S2
interface Eth-Trunk1
mode lacp
trunkport GigabitEthernet 0/0/1 to 0/0/3
port link-type trunk
port trunk allow-pass vlan 10 20

关闭g0/0/3