三层架构实验

实验拓扑和地址规划如下图所示

一、创建通道将两条主线绑定起到增加带宽的作用（分别sw1和sw2上）
[sw1]int g0/0/3
[sw1-GigabitEthernet0/0/3]eth-trunk 0
[sw1-GigabitEthernet0/0/3]int g0/0/2
[sw1-GigabitEthernet0/0/2]eth-trunk 0
[sw2-GigabitEthernet0/0/2]eth-trunk 0.
[sw2-GigabitEthernet0/0/2]int g0/0/1
[sw2-GigabitEthernet0/0/1]eth-trunk 0
二、给各个交换机上配置vlan，由于交换机内部自身携带vlan1，因此这里只需要给每一台交换机配置vlan2即可，并在PC2和PC4上配置vlan接口accss
[lsw1]vlan 2
[lsw1-vlan2]
[lsw3-Ethernet0/0/4]port link-type access
[lsw3-Ethernet0/0/4]port default vlan 2
[lsw 4-Ethernet0/0/4]port link-type access
[lsw 4-Ethernet0/0/4]port default vlan 2
三、给每一个交换机之间配置trunk干道
sw1
[lsw1]port-group group-member g0/0/2 g0/0/3
[lsw1-port-group]port link-type trunk
[lsw1-GigabitEthernet0/0/2]port link-type trunk
[lsw1-GigabitEthernet0/0/3]port link-type trunk
[lsw1-port-group]port trunk allow-pass vlan 2
[lsw1-GigabitEthernet0/0/2]port trunk allow-pass vlan 2
[lsw1-GigabitEthernet0/0/3]port trunk allow-pass vlan 2
sw2
[lsw2]port-group group-member g0/0/3 g0/0/2
[lsw2-port-group]port link-type trunk
[lsw2-GigabitEthernet0/0/3]port link-type trunk
[lsw2-GigabitEthernet0/0/2]port link-type trunk
[lsw2-port-group]port trunk allow-pass vlan 2
[lsw2-GigabitEthernet0/0/3]port trunk allow-pass vlan 2
[lsw2-GigabitEt