weixin_48671487的博客

#include <SPI.h>#include <MFRC522.h>#define SS_PIN 10#define RST_PIN 9int led=2;MFRC522 rfid(SS_PIN, RST_PIN); //创建MFRC522实例MFRC522::MIFARE_Key key;byte nuidPICC[4];void setup() {Serial.begin(9600);SPI.begin(); //初始化 SPI

#include <IRremote.h>//int RECV_PIN = 11;//int LED_PIN = 13;IRrecv irrecv(RECV_PIN);decode_results results;void setup(){Serial.begin(9600);irrecv.enableIRIn(); // Start the receiver// pinMode(LED_PIN, OUTPUT);// digitalWrite(LED_PIN, HIG

#include <SoftwareSerial.h>//使用软件串口，能将数字口模拟成串口SoftwareSerial BT(8, 9); //新建对象，接收脚为8，发送脚为9int led=11;char val; //存储接收的变量void setup() {Serial.begin(9600); //与电脑的串口连接Serial.println(“BT is ready!”);BT.begin(115200); //设置波特率}void loop() {/

#include<Keypad.h>#include<LiquidCrystal.h>LiquidCrystal lcd(13,12,11,A3,A2,A1,A0); //定义lcd液晶屏456引脚unsigned int data_t=0; //对按键进行计数，确定光标位置char num2=‘b’; //对第二个数的第一个数字进行标记，如果标记不改变，则按键数字为第一

int a = 8; //定义每一段数码管对应引脚int b = 7;int c = 6;int d = 5;int e = 4;int f = 3;int g = 2;int p = 1; //小数点int j;int key=A5; //控制按键，按一下加一int numTable[10][8] = {//a b c d e f g p{0,0,0,0,0,0,1,1 }, //0{1,0,0,1,1,1,1,1}, //1{0,0,1,0,0,1,0,1

物联网实验一 2021.3.24arduino按键控制LED 灯（按一下切换一次状态）#define led 13 //定义led灯为13引脚#define button 3 //定义button键盘为3引脚bool b1=false;int i;void keyScan(){if(digitalRead(button)==HIGH){delay(5);if(digitalRead(button)==HIGH){b1=!b1;while(digitalRead(butt