How to test a MOSFET using a multimeter easily?

如何使用万用表测试一个mosfet的完好性？

在实际的实验过程中，我们难免会碰到MOSFET疑似损坏的情况，此时则需要对MOSFET进行检查。

在检查工作前开始前，请先确认MOSFET的G、D、S级。

In our daily experiment procedure, you mightinevitably encounter a situation where you suspect your MOSFET were in a badcondition. At this point you may need to test your MOSFET.

Before the test starts, make sure you findout the Gate, Drain and Source terminals on your MOSFET.

 

器具：

万用表一个、待测MOSFET

Appliance:

One multimeter, MOSFET(to be tested).

 

 

检查步骤：

Test Procedure:

1.    是否短路  Shorten?

（1）万用表调至二极管导通档、正极接MOSFET的D级，负极接S级。若是短路万用表应有提示音。正常情况应无提示音。

Put your multimeter into a Diode-TestingMode first. Then put your positive lead to the Drain and negative lead to the Source.If the MOSFET is shorten, you’ll hear the notice sound ‘Di’. There should be noconnection if it works normally.

 

 

2. 导通状态是否正常 OnState?

（1）万用表调至二极管导通档，负极接S级，正极先轻触G级，接着接D级，正常万用表应提示连通。此时MOSFET类似电容，被充电。

Put your multimeter into a Diode-TestingMode first. Put the negative lead to the Source, touch the Gate briefly with thepositive lead then put it to the Drain. And there should be a connection afteryou put it back to the Drain. At this time the MOSFET works as a capacitor, we actuallycharge the capacitor.

 

（2）手指触碰G级和D级，连在一起，使其放电。随后使用负极接S，正极接D时则不提示连通，则为正常。

Touch the Gate and the Drain with yourfinger, connecting them together and making it discharging. Put the negative leadto the Source, and put the positive lead to the Drain. Then there should be noconnection to the Drain the Source now.