1、拔掉交换机的电源线。
2、用超级终端和控制线连到交换机,超级终端的设置是:
以下是引用片段: 9600 baud rate No parity 8 data bits 1 stop bit No flow control |
3、按住交换机前面板的“mode”按钮,插上电源线,当端口1上面的灯不亮后,放松“mode”按钮。
4、这时超级终端上应该显示:
以下是引用片段: The system has been interrupted prior to initializing the flash file system. The following commands will initialize the flash file system, and finish loading the operating system software: flash_init load_helper boot |
5、输入flash_init
6、输入load_helper
7、输入dir flash:
这时显示:
以下是引用片段: Directory of flash: 2 -rwx 843947 Mar 01 1993 00:02:18 C2900XL-h-mz-112.8-SA 4 drwx 3776 Mar 01 1993 01:23:24 html 66 -rwx 130 Jan 01 1970 00:01:19 env_vars 68 -rwx 1296 Mar 01 1993 06:55:51 config.text 1728000 bytes total (456704 bytes free) |
8、输入rename flash:config.text flash:config.old
9、输入boot,重新启动系统。
10、系统启动完后显示:Continue with the configuration dialog? [yes/no] :
输入N
11、输入enable
12、进入enable模式后,输入rename flash:config.old flash:config.text
13、接着按以下步骤操作:
以下是引用片段: Switch# copy flash:config.text system:running-config Source filename [config.text]? (press Return) Destination filename [running-config]? (press Return) |
14 、接着按以下步骤操作:
以下是引用片段: switch#configure terminal switch(config)#no enable secret switch(config)#no enable password switch(config)#exit switch#write memory |
这时,系统就恢复没有密码的状态了。
################################################################
1.先连接,打开securtCRT用serial登录
2.打开电源,在开机30秒内,按住交换机前面板左下方的MODE键
3.输入flash_init à 开始初始化FLASH
4.执行dir flash:命令
5.执行rename flash:config.text flash:config.old命令,进行更名含有password的配置文件。
6.执行boot命令进入交换机特权模式 (到此只密码恢复)
7.在出现“would you like to enter the initial configuration dialog?”[yes/no]时,输入“no”
8.输入enable命令进入交换机特权模式,执行switch#rename flash:config.old flash:config.text
9.执行copy flash:config.text system:running-config,此命令是拷贝配置文件到当前系统中,就是恢复原来交换机配置
10.最后 WR 将配置写入,SHOW RUN ,没问题就RELOAD