newStringUTF出现input is not valid Modified UTF-8错误解决办法

JNI调用newStringUTF时遇到不认识的字符串就直接出错退出~~,网上原因是dalvik/vm/CheckJni.c里面的checkUtfString函数检查通不过.找了半天没找到修正办法,把这个函数改了下,当做一个修正函数,下面是代码

void correctUtfBytes(char* bytes) {
  char three = 0;
   while (*bytes != '\0') {
	   unsigned char utf8 = *(bytes++);
	   three = 0;
	   // Switch on the high four bits.
	   switch (utf8 >> 4) {
	   case 0x00:
	   case 0x01:
	   case 0x02:
	   case 0x03:
	   case 0x04:
	   case 0x05:
	   case 0x06:
	   case 0x07:
		   // Bit pattern 0xxx. No need for any extra bytes.
		   break;
	   case 0x08:
	   case 0x09:
	   case 0x0a:
	   case 0x0b:
	   case 0x0f:
		   /*
			* Bit pattern 10xx or 1111, which are illegal start bytes.
			* Note: 1111 is valid for normal UTF-8, but not the
			* modified UTF-8 used here.
			*/
		   *(bytes-1) = '?';
		   break;
	   case 0x0e:
		   // Bit pattern 1110, so there are two additional bytes.
		   utf8 = *(bytes++);
		   if ((utf8 & 0xc0) != 0x80) {
			   --bytes;
			   *(bytes-1) = '?';
			   break;
		   }
		   three = 1;
		   // Fall through to take care of the final byte.
	   case 0x0c:
	   case 0x0d:
		   // Bit pattern 110x, so there is one additional byte.
		   utf8 = *(bytes++);
		   if ((utf8 & 0xc0) != 0x80) {
			   --bytes;
			   if(three)--bytes;
			   *(bytes-1)='?';
		   }
		   break;
	   }
   }
}