2021-06-12

springBoot连接redis报错

报错内容如下

-DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command ‘CONFIG SET protected-mode no’ from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to ‘no’, and then restarting the server. 3) If you started the server manually just for testing, restart it with the ‘–protected-mode no’ option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

解决办法

1.将redis.conf中的 protected-mode 从yes 改成mode
2.指定刚刚改动redis.conf为 启动配置文件
比如。
src/redis-server ./redis-conf

解决过程

按照提示更改了redis.conf配置文件的mode为 no

重启redis，结果还是报错了 。 又看了看防火墙，也是处于关闭状态。

但更改了配置重启依旧报一样的错。
。。。
怀疑是启动的配置文件没有被指定到。 于是我更改了配置文件的端口号

再次启动。

好家伙， 端口号都不一致。。。。。所以我尝试启动的时候指定配置文件

端口和配置文件一致了,再尝试用springboot连接 ，成功了。