nat试验

要求：

---

分析以及代码：

首先给所有接口以及设备配上ip地址

 

//AR1配置
[r1]int g0/0/0
[r1-GigabitEthernet0/0/0]ip add 192.168.1.1 24
[r1-GigabitEthernet0/0/0]int g0/0/1
[r1-GigabitEthernet0/0/1]ip add 12.1.1.1 24


//AR2配置
[r2]int g0/0/0
[r2-GigabitEthernet0/0/0]ip add 12.1.1.2 24
[r2-GigabitEthernet0/0/0]int g0/0/1
[r2-GigabitEthernet0/0/1]ip add 1.1.1.1 24

 

 

 

 

 

 

 然后在AR1上面写路由以及acl规则

[r1]ip route-static 0.0.0.0 0 12.1.1.2
[r1]acl 2000
[r1-acl-basic-2000]rule permit source 192.168.1.0 0.0.0.255
[r1-acl-basic-2000]int g0/0/1
[r1-GigabitEthernet0/0/1]nat outbound 2000

[r1-GigabitEthernet0/0/1]nat server protocol tcp global current-interface 80 ins
ide 192.168.1.10 80
Warning:The port 80 is well-known port. If you continue it may cause function fa
ilure.
Are you sure to continue?[Y/N]:y

[r1-GigabitEthernet0/0/1]nat server protocol tcp global current-interface 90 ins
ide 192.168.1.20 80
Warning:The port 90 is well-known port. If you continue it may cause function fa
ilure.
Are you sure to continue?[Y/N]:y

实验：首先访问端口

 然后访问域名：