Making a GRUB bootable CD-ROM

Making a GRUB bootable CD-ROM

GRUB supports the no emulation mode in the El Torito specification¹. This means that you can use the whole CD-ROM from GRUB and you don't have to make a floppy or hard disk image file, which can cause compatibility problems.

For booting from a CD-ROM, GRUB uses a special Stage 2 called stage2_eltorito. The only GRUB files you need to have in your bootable CD-ROM are this stage2_eltorito and optionally a config file menu.lst. You don't need to use stage1 or stage2, because El Torito is quite different from the standard boot process.

Here is an example of procedures to make a bootable CD-ROM image. First, make a top directory for the bootable image, say, iso:

     $ mkdir iso
     

Make a directory for GRUB:

     $ mkdir -p iso/boot/grub
     

Copy the file stage2_eltorito:

     $ cp /usr/share/grub/i386-pc/stage2_eltorito iso/boot/grub
     

If desired, make the config file menu.lst under iso/boot/grub (see Configuration), and copy any files and directories for the disc to the directory iso/.

Finally, make a ISO9660 image file like this:

     $ mkisofs -R -b boot/grub/stage2_eltorito -no-emul-boot /
         -boot-load-size 4 -boot-info-table -o grub.iso iso
     

This produces a file named grub.iso, which then can be burned into a CD (or a DVD). mkisofs has already set up the disc to boot from the boot/grub/stage2_eltorito file, so there is no need to setup GRUB on the disc. (Note that the -boot-load-size 4 bit is required for compatibility with the BIOS on many older machines.)

You can use the device (cd) to access a CD-ROM in your config file. This is not required; GRUB automatically sets the root device to (cd) when booted from a CD-ROM. It is only necessary to refer to (cd) if you want to access other drives as well.