nrf51822发射功率

转自：http://www.cnblogs.com/libra13179/p/5377107.html

设置蓝牙的TX Power

 

使用的函数sd_ble_gap_tx_power_set(int8_t tx_power);

 

参看例子为 S110/ble_app_proximity

#define TX_POWER_LEVEL                      (4)                                              /**< TX Power Level value. This will be set both in the TX Power service, in the advertising data, and also used to set the radio transmit power. */

 

 

static void gap_params_init(void)
{
    uint32_t                err_code;
    ble_gap_conn_params_t   gap_conn_params;
    ble_gap_conn_sec_mode_t sec_mode;

    BLE_GAP_CONN_SEC_MODE_SET_OPEN(&sec_mode);
   
    err_code = sd_ble_gap_device_name_set(&sec_mode, (const uint8_t *)DEVICE_NAME, strlen(DEVICE_NAME));
    APP_ERROR_CHECK(err_code);

    err_code = sd_ble_gap_appearance_set(BLE_APPEARANCE_GENERIC_KEYRING);
    APP_ERROR_CHECK(err_code);
   
    memset(&gap_conn_params, 0, sizeof(gap_conn_params));

    gap_conn_params.min_conn_interval = MIN_CONN_INTERVAL;
    gap_conn_params.max_conn_interval = MAX_CONN_INTERVAL;
    gap_conn_params.slave_latency     = SLAVE_LATENCY;
    gap_conn_params.conn_sup_timeout  = CONN_SUP_TIMEOUT;

    err_code = sd_ble_gap_ppcp_set(&gap_conn_params);
    APP_ERROR_CHECK(err_code);

    err_code = sd_ble_gap_tx_power_set(TX_POWER_LEVEL);
    APP_ERROR_CHECK(err_code);
}

 

可以设置的输出的功率为 accepted values are -40, -30, -20, -16, -12, -8, -4, 0, and 4 dBm

/**@brief Set the radio's transmit power.
*
* @param[in] tx_power Radio transmit power in dBm (accepted values are -40, -30, -20, -16, -12, -8, -4, 0, and 4 dBm).
*
* @note -40 dBm will not actually give -40 dBm, but will instead be remapped to -30 dBm.
*
* @return @ref NRF_SUCCESS Successfully changed the transmit power.
* @return @ref NRF_ERROR_INVALID_PARAM Invalid parameter(s) supplied.
* @return @ref NRF_ERROR_BUSY The stack is busy, process pending events and retry.
*/
SVCALL(SD_BLE_GAP_TX_POWER_SET, uint32_t, sd_ble_gap_tx_power_set(int8_t tx_power));