树莓派zerow新机开箱设置

最新推荐文章于 2021-12-01 15:10:07 发布

淮南草

最新推荐文章于 2021-12-01 15:10:07 发布

阅读量815

点赞数

分类专栏：树莓派

本文链接：https://blog.csdn.net/zhuisaozhang1292/article/details/105467215

版权

本文介绍了如何为树莓派Zero W设置无头操作，利用USB端口模拟网卡，通过SSH和VNC进行远程访问。在Windows 10上，需要手动安装RNDIS驱动。步骤包括格式化SD卡，烧录Raspbian映像，修改配置文件，启用SSH，安装驱动，最后使用Putty和VNC Viewer连接。

摘要由CSDN通过智能技术生成

1. 通过修改树莓派系统的配置 ,打开usb端口模拟网卡的功能.然后可以通过这个虚拟的网口,用ssh方式或者vnc方式控制树莓派.对树莓派0这种端口很少的设备非常管用.

2.是usb端口,不是usb供电口

3.把镜像烧录到tf卡上之后,修改几个配置即可.

4.win10原生认不出来usb模拟网卡.需要下载驱动.

5.默认登录地址是pi@raspberrypi.local.密码是raspberry

6.通过vncserver启动远程登录的虚拟界面服务器.地址是raspberrypi.local:1

Setting up a headless setup for Pi Zero W is simple. The limitation of Pi Zero and Zero W is that it doesn’t have an Ethernet port. All we have is a single USB port. We need to use it as an Ethernet via USB technique to access the Pi. There are many tutorials available for this. But if you are using Windows 10 you might be faced the problem with RNDIS driver. The RNDIS driver will install automatically on all operating systems but not in Windows 10. In Windows10 the Pi Zero W detects as a Serial USB Device instead of RNDIS Device. RNDIS is an Ethernet via USB driver which enables virtual Ethernet connection link between the Pi and your Laptop. I tried downloading the drivers and installed but most drivers didn’t work. Then finally I found a driver link in a forum and I tried installing it manually and it’s worked. So I’m going to explain the complete steps for this headless setup along with driver installation. If you are facing issue only at the driver installation part you can directly continue with step 9.

Hardware Required:

Software Required for Headless setup: