centos7 防火墙 配置 无iptables的解决方法

centos7系统中，在/etc/sysconfig   下没有iptables文件，无法配置防火墙。按照网上的解决方法报错如下：

经实验，有效方法如下：

With RHEL 7 / CentOS 7, firewalld was introduced to manage iptables. IMHO, firewalld is more suited for workstations than for server environments.

It is possible to go back to a more classic iptables setup. First, stop and mask the firewalld service:
 

systemctl stop firewalld
systemctl mask firewalld

Then, install the iptables-services package:

yum install iptables-services

Enable the service at boot-time:

systemctl enable iptables

Managing the service

systemctl [stop|start|restart] iptables

Saving your firewall rules can be done as follows:

service iptables save

至此，在sysconfig中ls，即可找到iptables文件。

如需要添加防火墙规则，编辑vim iptables。把 规则添加到防火墙配置的最后一行，导致防火墙启动失败，正确的应该是添加到默认的22端口这条规则的下面。

添加好之后防火墙规则如下所示：
######################################
# Firewall configuration written by system-config-firewall
# Manual customization of this file is not recommended.
*filter
:INPUT ACCEPT [0:0]
:FORWARD ACCEPT [0:0]
:OUTPUT ACCEPT [0:0]
-A INPUT -m state –state ESTABLISHED,RELATED -j ACCEPT
-A INPUT -p icmp -j ACCEPT
-A INPUT -i lo -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 22 -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 80 -j ACCEPT
-A INPUT -m state –state NEW -m tcp -p tcp –dport 3306 -j ACCEPT
-A INPUT -j REJECT –reject-with icmp-host-prohibited
-A FORWARD -j REJECT –reject-with icmp-host-prohibited
COMMIT
#####################################

/etc/init.d/iptables restart      #最后重启防火墙使配置生效