ADC的最基本的例程。
硬件环境:TG STK, 输入通道选择PD5,TG STK 外扩20pin引脚的第14pin, 即为PD5. 可以用来外接输入电压。 参考电源选择内部的Vdd。
软件环境: IAR
例程:
#include "efm32.h"
#include "efm32_chip.h"
#include "efm32_gpio.h"
#include "efm32_cmu.h"
#include "efm32_adc.h"
#define ADC_Convert_Speed 400000 //ADC转换速率
#define ADC_Reference adcRefVDD //ADC参考电压选择
#define ADC_Input adcSingleInpCh5 //ADC输入通道选择
#define ADC_Resolution adcRes12Bit //ADC转换分辨率选择
unsigned long ADC_Sensor_Get_ADC(void)
{
/* Enable clocks required */
CMU_ClockEnable(cmuClock_HFPER, true);
CMU_ClockEnable(cmuClock_ADC0, true);
ADC_Init_TypeDef init = ADC_INIT_DEFAULT;
ADC_InitSingle_TypeDef singleInit = ADC_INITSINGLE_DEFAULT;
/* Init common settings for both single conversion and scan mode */
init.timebase = ADC_TimebaseCalc(0);
/* Might as well finish conversion as quickly as possibly since polling */
/* for completion. */
/* Set ADC clock to 200kHz, use default HFPERCLK */
init.prescale = ADC_PrescaleCalc(ADC_Convert_Speed, 0);
/* WARMUPMODE must be set to Normal according to ref manual before */
/* entering EM2. In this example, the warmup time is not a big problem */
/* due to relatively infrequent polling. Leave at default NORMAL, */
ADC_Init(ADC0, &init);
/* Init for single conversion use, measure VDD/3 with 1.25 reference. */
singleInit.reference = ADC_Reference;
singleInit.input = ADC_Input;
singleInit.resolution = ADC_Resolution;
/* The datasheet specifies a minimum aquisition time when sampling vdd/3 */
/* 32 cycles should be safe for all ADC clock frequencies */
singleInit.acqTime = adcAcqTime64;
ADC_InitSingle(ADC0, &singleInit);
unsigned long ulADC_Value = 0;
/* Start ADC convert by Software trigger */
ADC_Start(ADC0, adcStartSingle);
/* Wait while conversion is active */
while (ADC0->STATUS & ADC_STATUS_SINGLEACT) ;
/* Get ADC result */
ulADC_Value = ADC_DataSingleGet(ADC0);
CMU_ClockEnable(cmuClock_ADC0, false);
return ulADC_Value;
}
int main(void)
{
CHIP_Init();
while (1)
{
unsigned long ulDelay = 100000;
while(ulDelay--);
ADC_Sensor_Get_ADC();
}
}