redis 报错 Redis protected-mode 配置文件没有真正启动

(error) DENIED Redis is running in protected mode because protected mode is enabled

  • Redis protected-mode 是3.2 之后加入的新特性,在Redis.conf的注释中,我们可以了解到,他的具体作用和启用条件

链接redis 时只能通过本地localhost (这个来链接,而不能用网络ip(192.168..)这个链接,问题然如果用网络ip 链接会报以下的错误:

(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the lookback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the --portected-mode no option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.


# bind 


daemonize no


protected-mode no 

没反应应该是你启动服务端的时候没有带上配置文件。你可以./redis-server redis.conf

$ redis-server redis.conf

如果还是所某个端口已在使用,那么可能是有 后台程序在占用该端口,需要kill 掉该程序,重新带上配置文件。./redis-server redis.conf启动。

$ ps -ef | grep redis | awk ‘{print $2}’ | xargs kill -9


©️2020 CSDN 皮肤主题: 编程工作室 设计师:CSDN官方博客 返回首页