Redis is running in protected mode

这是redis在安装后，如果非本机访问的话，会报的一个错误，这个错误还是比较长的：

Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the lookback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the --portected-mode no option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

谷歌翻译一下：

Redis在保护模式下运行，因为启用了保护模式，未指定绑定地址，未向客户端请求身份验证密码。在此模式下，仅从回溯接口接受连接。如果要从外部计算机连接到Redis，则可以采用以下解决方案之一：

1）只需禁用受保护模式，方法是通过从服务器的同一主机连接到Redis，从回送接口发送命令“ CONFIG SET protected-mode no”。正在运行，但是请确保不能从Internet公开访问Redis。使用CONFIG REWRITE使更改永久生效。

2）或者，您可以通过编辑Redis配置文件，并将保护模式选项设置为“ no”，然后重新启动服务器来禁用保护模式。

3）如果仅出于测试目的手动启动服务器，请使用--portected-mode no选项重新启动服务器。

4）设置绑定地址或身份验证密码。注意：您只需执行上述操作之一，服务器就可以开始接受来自外部的连接。 

这四个任意做一个都行，一般选择第二个，配置文件改成protected-mode = no